VPN: Site to Site and Remote Access source NAT IPSec traffic entering an IPSec tunnel

UTM Firewall requires membership for participation - click to join

Thread Info

State Not Answered
Locked Locked
Replies 5 replies
Subscribers 1 subscriber
Views 4353 views
Users 0 members are here

Options

Suggested

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

source NAT IPSec traffic entering an IPSec tunnel

StephanG over 10 years ago

Hello,

i need to establish a connection described like here:
Technical Note : How to source NAT IPSec traffic entering an IPSec tunnel with a specific IP address in Site to Site configuration

I could not find a KB article or forum article. Can anyone help me with this?

Best regards
Stephan

This thread was automatically locked due to age.

0 BarryG over 10 years ago

Hi, an SNAT should wok; have you tried it?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 StephanG over 10 years ago in reply to BarryG

Hello Barry,

i cannot try it yet because it's another company we need to establish this "special" connection to.

So i just wanted to be sure that it does not consume much time with trial and error.

Regards
Stephan
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 10 years ago

I think it'd work, but you could check with your reseller.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 StephanG over 10 years ago in reply to BarryG

I will try and post the solution here (if i can make it [;)] )

Best regards
Stephan
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 10 years ago

You might find the following article helpful as the solution depends on the same technique you're asking about: How to tunnel between two UTMs which use the same LAN network range.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel