This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Network Extension via two UTMs

Just to start, I am a complete n00b on VPNs and am trying my best to learn, however I have been put in a position to solve a problem quickly, so here goes.

I am needing to connect two geographically separate LANs via bridge and maintain the same IP space on each. I setup two software UTM 9s on a ESXi host to work with for proof of concept. What I HAVE been able to accomplish is build RED tunnel or an IPSec tunnel between the two and allow different networks to communicate, but I need a single network to span them both.

Is this even possible with UTM 9s in a software only configuration?

I have tried bridging the redsX and eth1 interface on one and trying to get the other to manage the network via this post: https://community.sophos.com/products/unified-threat-management/astaroorg/f/62/t/57348
with no luck.

Any suggestions?

This thread was automatically locked due to age.

Parents

0 BAlfson over 10 years ago

I haven't really worked with a Paint equivalent on OS X.

Too many toys, too little time! [;)]

The RED pic is of the Client side - we need to look at the Server side Edit.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 goosen8r over 10 years ago in reply to BAlfson

That was the server....at least it's the UTM I used to create the config and download the config file for the second one. Attached is the full shot.
Cancel
Vote Up 0 Vote Down

Cancel
0 goosen8r over 10 years ago in reply to goosen8r

Here is the client side for reference.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 goosen8r over 10 years ago in reply to goosen8r

Here is the client side for reference.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data