This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

S2S VPN access multiple subnets

Here is my situation. I have a UTM110 to UTM320 site 2 site VPN. The tunnel is up and i can see both subnets. Here is where i am having my issues. On the 320 side i have a MPLS network and need the 110 side to be able to access all of the subnets. any help would be great. I also set up the UTM 2 UTM RED and had the same issue.

Thanks in advance.

This thread was automatically locked due to age.

0 Scott_Klassen over 10 years ago

On the 320 side as local network and on the 110 side as a remote network, have you added the MPLS network?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 bbolander over 10 years ago

Thanks but yes i already have the local and remote networks in on both sides.
Cancel
Vote Up 0 Vote Down

Cancel
0 pedja over 10 years ago

Hi,

Verify the following:
1. Your 320 and 110 have same VPN settings for both ends (including the MPLS networks).
2. Your 320 has appropriate routes to the MPLS networks.
3. Your MPLS networks have appropriate routes to the network(s) that are connected to UTM320 and UTM110.
4. The subnets are not overlapping.
5. Appropriate firewall rules exist to allow this communication.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 10 years ago

This is, basically, the same issue as in Hub and Spoke Help. I think you didn't understand Scott's question.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel