Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 9 replies
  • Subscribers 1 subscriber
  • Views 3980 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IpSec VPN - can't access NAS

marcusamice
Hi, 
Just got started with sophos UTM's.
Implemented an IpSec tunnel between to UTM9-110/120.
No errors in the UTM gui. I can ping the IP's on the other side.
An IP-scan-tool gives a list of discovered IP's.

I want to access the management interface of a NAS (115.115.101.20).
No luck with that [:S]

Site A: 192.168.1.0/24 (site where i'am on)
Site B: 115.115.101.0/24

What is this newbie missing?
Grtz, M.


This thread was automatically locked due to age.
Parents
  • 0
    Hi, Marcus, and welcome to the User BB!

    In fact, the automatic rules have precedence over manually-created ones.  Consider the https://community.sophos.com/products/unified-threat-management/astaroorg/f/51/t/22065, especially #2 and #3.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0 in reply to BAlfson
    I´ll try to explain it further, as a newbie.
    I used a faulty "network" definition in the field "remote networks" of the "Remote Gateway" i used for the "IPsec Connection". The "network definition" (under the "advanced tab") I binded to an interface. Result: no trafiic possible over the tunnel.
    The rule i created for troubleshooting did make traffic possible over the tunnel.

    When > was selected it worked as it should.

    Does my best try makes any sense?
Reply
  • 0 in reply to BAlfson
    I´ll try to explain it further, as a newbie.
    I used a faulty "network" definition in the field "remote networks" of the "Remote Gateway" i used for the "IPsec Connection". The "network definition" (under the "advanced tab") I binded to an interface. Result: no trafiic possible over the tunnel.
    The rule i created for troubleshooting did make traffic possible over the tunnel.

    When > was selected it worked as it should.

    Does my best try makes any sense?
Children
No Data
Unfiltered HTML