This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VPN issues...

Hello everyone.

I have set up a site to site VPN with a Cisco ASA. Tunnel is up and I can ping the remote network from my ASG, but not from my local network. I think I am missing something stupid but don't know what. Any ideas?

Thanks in advance.

Richard

This thread was automatically locked due to age.

Parents

0 BarryG over 11 years ago

Hi,

0. Do you have Ping enabled in the ICMP settings on the UTM?

1. you might need to define routes on the Cisco end

2. you defined the remote networks on the Cisco, right?

3. check all the logs

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 ccnaman over 11 years ago in reply to BarryG

Thanks for the reply BarryG. Yes, I have ICMP enabled. I don't have access to the Cisco, it is an outside vendor. I will look into the logs. I am just wondering if there is something else I need to do on the ASG, some definition I need to set up?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 ccnaman over 11 years ago in reply to BarryG

Thanks for the reply BarryG. Yes, I have ICMP enabled. I don't have access to the Cisco, it is an outside vendor. I will look into the logs. I am just wondering if there is something else I need to do on the ASG, some definition I need to set up?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

VPN issues...

Submitted a Tech Support Case lately from the Support Portal?