Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 1 subscriber
  • Views 2665 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSL VPN Static IP adress

SnurrDass
I did what it say in the PDF and it dint work.

i created a host at IP 192.168.0.100 and did Snat/dnat as it say in det document. but dint work.

is there enny changes from this Astaro version to todays UTM version that this document dont have?

https://sophserv.sophos.com/repo_kb/115930/file/SSL_VPN_Static_IP_addresses.pdf


This thread was automatically locked due to age.
  • 0
    Dan,

    What do you observe that makes you say it's not working?  What are "Internal (Network)" and "VPN Pool (SSL)" definitions?

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0 in reply to BAlfson
    Dan,

    What do you observe that makes you say it's not working?  What are "Internal (Network)" and "VPN Pool (SSL)" definitions?

    Cheers - Bob


    Factory Default.
    have not change it.

    have only added a host def. at 192.168.0.100
    and SNAT and DNAT rules
  • 0
    Does the Host definition have 'Interface: >'?

    Cheers - Bob

    Sorry for any short responses.  Posted from my iPhone.
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0
    the remote Computer have full access to Internal network.
    i have VNC installed on the remote and i can connect to it by using the ip given by the SSL VPN pool.
    i cant connet from internal network to the remote by SMB, but that i think is FW/sharing settings on the remote computer that is not correct.

    when doing the SNAT and DNAT i couldt connect to the VNC at all.
    so the translation from User to static IP did not work so smoothly as i hope [;)]

    i have posted a screenshoot of SSL settings that showin that remote shuld have internal network access, and that bit of settings work.
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?

Unfiltered HTML