This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

End to Site to Site or: How to?

Hello everyone,

I am planning to do a classic scenario, however, the FAQ and KBs don't help me at all.

My idea is as this




My Laptop --- VPN (L2TP) ---- my UTM ====== IPSec ==== my friend's UTM ----- his network

Seems easy, but what configurations do I have to do? What firewall rules, what NAT masking?

I appreciate your suggestions.

Regards

ZeroEnna

This thread was automatically locked due to age.

Parents

0 apijnappels over 11 years ago

Your UTM would need to offer the local IP-range as well as the L2TP IP-range as local networks and connect to your friend's IP-range as remote network.
On your friends UTM this needs to be the other way around (local/remote switched).

However if you have the default IP-range voor L2TP-VPN on both sites, then both UTM's have this range as a local range and therefore might not send this traffic into the tunnel. You could try to change this range on one UTM and see what happens.

Also you could try to use SNAT on your UTM where you change the source address of your L2TP traffic to be coming from your UTM's local LAN for the destination of your friends network.

Managing several Sophos UTMs and Sophos XGs both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.

Sometimes I post some useful tips on my blog, see blog.pijnappels.eu/category/sophos/ for Sophos related posts.
Cancel
Vote Up 0 Vote Down

Cancel
0 ZeroEnna over 11 years ago in reply to apijnappels

With your SNAT Approach, I can finally ping the remote network's clients.
However, it seems that no DNS resolution is possible once I connect to my Network via L2TP.

Any ideas?
Cancel
Vote Up 0 Vote Down

Cancel
0 apijnappels over 11 years ago in reply to ZeroEnna

With your SNAT Approach, I can finally ping the remote network's clients.
However, it seems that no DNS resolution is possible once I connect to my Network via L2TP.

Any ideas?

In stead of using the IP address pool you could configure a DHCP scope on a DHCP server (maybe it's even possible on the UTM but I'm not sure since there's no real interface connected to LT2P traffic). In DHCP you can add DHCP-options for DNS-servers and domain-suffix if needed.

Managing several Sophos UTMs and Sophos XGs both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.

Sometimes I post some useful tips on my blog, see blog.pijnappels.eu/category/sophos/ for Sophos related posts.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 apijnappels over 11 years ago in reply to ZeroEnna

With your SNAT Approach, I can finally ping the remote network's clients.
However, it seems that no DNS resolution is possible once I connect to my Network via L2TP.

Any ideas?

In stead of using the IP address pool you could configure a DHCP scope on a DHCP server (maybe it's even possible on the UTM but I'm not sure since there's no real interface connected to LT2P traffic). In DHCP you can add DHCP-options for DNS-servers and domain-suffix if needed.

Managing several Sophos UTMs and Sophos XGs both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.

Sometimes I post some useful tips on my blog, see blog.pijnappels.eu/category/sophos/ for Sophos related posts.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

End to Site to Site or: How to?

Submitted a Tech Support Case lately from the Support Portal?