Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 1 subscriber
  • Views 4110 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

BGP Not working for IPSEC Site to Site VPN

Shway
Greetings,

My BGP setup is not working. Here is my Configuration:

Neighbors
: 169.254.255.78/30 (Sophos) - Mine
AS 7224

: 169.254.255.77/30 (Juniper SRX 210) - Site
AS 65100

The issue I am having is my BGP is not working. I am thinking it is my configuration in the Sophos UTM9. In order to figure out if this is my issue or my remote sites issue, I need a step by step on how to add a proper BGP configuration to Sophos, correctly. As I think I muddled it up. The end point unit is a Juniper SRX 210.

Thank you community! I really appreciate your help with this!


This thread was automatically locked due to age.
Parents
  • 0
    Hi,

    1. upgrade to 9.006 (but not to 9.1x). I don't know if it'll help with BGP, but there are lots of improvements.

    2. open a support case if you have a support contract.

    3. check the logs on both ends of the connection.

    4. run sniffers on both ends.

    question: are those the actual IP networks? are they both on your local network? My understanding is that 169.254.0.0/16 is reserved per rfc3927.

    Barry
Reply
  • 0
    Hi,

    1. upgrade to 9.006 (but not to 9.1x). I don't know if it'll help with BGP, but there are lots of improvements.

    2. open a support case if you have a support contract.

    3. check the logs on both ends of the connection.

    4. run sniffers on both ends.

    question: are those the actual IP networks? are they both on your local network? My understanding is that 169.254.0.0/16 is reserved per rfc3927.

    Barry
Children
No Data
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?

Unfiltered HTML