This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Default firewall rules

Hi Group,

Have a question on point to point ipsec configurations.  When I choose to allow "Automatic firewall rules" in the connection, what exactly are those rules?  Allow any/any on the tunnel?

How exactly would one implement a stricter set of rules?  Do I simply have to make the rule in the firewall section?  Or, do I have to go into NAT (both masquerade and DNAT/SNAT?)

Is there a way to see all the rules that are implemented?  Any tips or guides appreciated.

This thread was automatically locked due to age.

Parents

0 BarryG over 12 years ago

Hi,
Disable the automatic rule, and create a rule using the SQL service for the source IP on the other end, and the SQL server IP as the destination.

What NAT/Masq rules do you have now?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 tom11011 over 12 years ago in reply to BarryG

>>>What NAT/Masq rules do you have now?

Nothing at all specific to the tunnel, just wanted to know if I will need anything specific to the tunnel.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 tom11011 over 12 years ago in reply to BarryG

>>>What NAT/Masq rules do you have now?

Nothing at all specific to the tunnel, just wanted to know if I will need anything specific to the tunnel.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Default firewall rules

Submitted a Tech Support Case lately from the Support Portal?