This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Selected hosts reach other hosts S2S-IPSec

Hi all,

I have succesfully setup an Site-2-Site IPSec connection.But now the whole network is accessible on both sites.
I just want a few computers who can access computers on the remote site, not the whole LAN.
I tried to set in the IPSec settings just the hosts not the LAN, but this seems not to work.
Also I tried to not use "Automatic Firewall" but then still the 2 LAN's can reach each other (all hosts).

How do I accomplish that selected hosts (LAN1) can reach selected hosts (LAN2) over IPSec?

TIA,

Fobe

This thread was automatically locked due to age.

0 nuber1ous over 12 years ago

Hi fobe,

You may try the following:

-Unselect the "Automatic Firewall Rules" on both IPSEC Connections
-Disable/Enable the IPSEC Connection to break and recreate the tunnel
-Define manually the accept firewall policies for the remote host on the destination firewall

br
yvan
Cancel
Vote Up 0 Vote Down

Cancel
0 PabloDiablo over 12 years ago

thanks for the reply. I had to disable/enable the tunnel. That did the trick
Cancel
Vote Up 0 Vote Down

Cancel

Selected hosts reach other hosts S2S-IPSec

Submitted a Tech Support Case lately from the Support Portal?