Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Interface For SSL Tunnel

Anyone know or have any ideas how to add the tunnel interface ie:tun0 as an interface on the interfaces tab?

my goal here is to route some of my internet traffic over the VPN tunnel I have created while allowing other traffic to pass through the local gateway...


This thread was automatically locked due to age.
Parents
  • Since I haven't configured a pfSense, I'm not sure what I'm seeing in your pictures, but clearly you know how to use it to create the solutions you need.  In versions prior to V9, the tun# and ipsec# interfaces are available at the command line, but there was no place to use them in WebAdmin.

    The issue you described is solved differently with this software - I haven't encountered a situation where I was unable to select what traffic goes through a tunnel.  I suspect that the items you want to create are done automatically by WebAdmin when the client-side SSL VPN is uploaded.  Perhaps someone here with more pfSense knowledge can confirm/deny my suscpicions.

    Cheers - Bob
Reply
  • Since I haven't configured a pfSense, I'm not sure what I'm seeing in your pictures, but clearly you know how to use it to create the solutions you need.  In versions prior to V9, the tun# and ipsec# interfaces are available at the command line, but there was no place to use them in WebAdmin.

    The issue you described is solved differently with this software - I haven't encountered a situation where I was unable to select what traffic goes through a tunnel.  I suspect that the items you want to create are done automatically by WebAdmin when the client-side SSL VPN is uploaded.  Perhaps someone here with more pfSense knowledge can confirm/deny my suscpicions.

    Cheers - Bob
Children
No Data