This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

site to site ipsec vpn public network as remote network

Hi,

I have an ipsec vpn between a asg8 and à cisco ASA 5520.

- On the ASA side there is a private network and a public network

- On ASg 8 side there is only one private network

The tunnel is up and we can see the isakmp sa and ipsec sa, but only the private networks are reachable. the public network behing the ASA is not reachable.

there is no nat configure for this tunnel.

Thanks

Inle

This thread was automatically locked due to age.

Parents

0 BAlfson over 12 years ago

Please [Go Advanced] below and show a picture of the Edit of the 'Remote Gateway' as defined in the Astaro and of the 'IPsec Connection'.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 12 years ago

Please [Go Advanced] below and show a picture of the Edit of the 'Remote Gateway' as defined in the Astaro and of the 'IPsec Connection'.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 inle over 12 years ago in reply to BAlfson

Please [Go Advanced] below and show a picture of the Edit of the 'Remote Gateway' as defined in the Astaro and of the 'IPsec Connection'.

Cheers - Bob

Hi those are the values of the remote gateway configuration:

Name: ASA
Gateway type: Initiate connection
Gateway ASA-GW
Authentication type: Preshared key
VPn ID type IP Address
Remote Network ASA-internal
Cancel
Vote Up 0 Vote Down

Cancel

site to site ipsec vpn public network as remote network

Submitted a Tech Support Case lately from the Support Portal?