Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSec (Cisco) & iPhone

Hey all,

Just did a reset on my unit to set up my FQDN for the Cisco VPN/iPhone configuration - but still having no luck.  I've followed the guides and setup the users, downloaded the config file from the portal to the iPhone but whenever I try to connect I get: 

"The VPN server did not respond."

I'm not getting any hits in the live log at all.  The Astaro is currently behind another router (while I'm setting it up) but I have DMZed it so in theory it shouldn't have any issues.  

I'm running 9.002-12 & trying to connect with an iPhone 4S on 5.1.1.  Can someone give me some tips on how to get this going?


This thread was automatically locked due to age.
Parents
  • It sounds like your configuration issue is in the edge router.

    Once you get that resolved, I don't know that it's possible to get an IPsec connection going if the server is behind a NATting router; that is, I don't know that either the L2TP or Cisco client can adjust to the fact that the IP on the server is different from the IP of the FQDN the clients call.  Unless you can get the UTM to the edge and get a public IP on it, you're probably limited to PPTP with your iPhone.

    Cheers - Bob
Reply
  • It sounds like your configuration issue is in the edge router.

    Once you get that resolved, I don't know that it's possible to get an IPsec connection going if the server is behind a NATting router; that is, I don't know that either the L2TP or Cisco client can adjust to the fact that the IP on the server is different from the IP of the FQDN the clients call.  Unless you can get the UTM to the edge and get a public IP on it, you're probably limited to PPTP with your iPhone.

    Cheers - Bob
Children
No Data