This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multiple Site-to-Site-VPN

Hey everyone,

I didn't find anything regarding this in the KB, neither on the board.

I use to have a VPN connection established to my best friend's network (that is, until my old Astaro appliance chose to switched to Pikachu mode and gave me a good buzz).
Now, another friend decided to use an Astaro in her home network.

Now the question: How to establish a multisite-VPN using only the UTM Home edition. Is it an 1:1 connection between one "core site" yor do we have to established a triangular connection?
What about routing?

Thank you in advance

Kind regards

zero

This thread was automatically locked due to age.

Parents

0 BAlfson over 13 years ago

Yes, the trick is to use "Uplink Interfaces" in the 'IPsec Connection' on the side with two WAN connections, and bind 'Any -> IPsec -> {other endpoint}' traffic to interface #1. On the other side, in the 'Remote Gateway' definition, use an 'Availability Group' containing the IPs of the first side with the IP of #1 in the first position.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 13 years ago

Yes, the trick is to use "Uplink Interfaces" in the 'IPsec Connection' on the side with two WAN connections, and bind 'Any -> IPsec -> {other endpoint}' traffic to interface #1. On the other side, in the 'Remote Gateway' definition, use an 'Availability Group' containing the IPs of the first side with the IP of #1 in the first position.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data