Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 13 replies
  • Subscribers 1 subscriber
  • Views 4772 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

User VPN remote to specific IP Address

csfong
hi ,

Trying to setup user to remote VPN via SSL connection to one specific IP host address.. 

from the packet filter  i direct  csfong(user network) --> http --> caweb (ip host) , putting thisinto the top 

another filter   csfong(user network) --> any -->when I connected , it allow me to goes any where.  i must have done something less, please advice. Thanks
 network.jpg

Packet.jpg

csfongnetwork.jpg


regards.csfong


This thread was automatically locked due to age.
Parents
  • 0
    If csfong is logged in via VPN, the object should have an IP.

    I notice that you have a definition bound to an interface.  That can cause routing problems.  You should go through all of your definitions and set each one to 'Interface: >'.

    Cheers - Bob
Reply
  • 0
    If csfong is logged in via VPN, the object should have an IP.

    I notice that you have a definition bound to an interface.  That can cause routing problems.  You should go through all of your definitions and set each one to 'Interface: >'.

    Cheers - Bob
Children
No Data