Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 13 replies
  • Subscribers 1 subscriber
  • Views 4785 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

User VPN remote to specific IP Address

csfong
hi ,

Trying to setup user to remote VPN via SSL connection to one specific IP host address.. 

from the packet filter  i direct  csfong(user network) --> http --> caweb (ip host) , putting thisinto the top 

another filter   csfong(user network) --> any -->when I connected , it allow me to goes any where.  i must have done something less, please advice. Thanks
 network.jpg

Packet.jpg

csfongnetwork.jpg


regards.csfong


This thread was automatically locked due to age.
Parents
  • 0
    Ok - that looks correct. 

    One possible problem could be that the IP adress of the logged in user csfong is not propagated to user(network) object so that rule 1 & 2 don't match and the last rule matches. You can verify if that is the problem if you vpn in with the user csfong and then check in the network definitions if the object csfong (user network) is resolved to an adress.

    Regards
    Manfred
Reply
  • 0
    Ok - that looks correct. 

    One possible problem could be that the IP adress of the logged in user csfong is not propagated to user(network) object so that rule 1 & 2 don't match and the last rule matches. You can verify if that is the problem if you vpn in with the user csfong and then check in the network definitions if the object csfong (user network) is resolved to an adress.

    Regards
    Manfred
Children
No Data