This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cisco ASA 5505 to ASG

Hi,

I've succefully connected an ASG to a Cisco ASA (https://kb-beta.astaro.com/support/index.php/ASG_V7_to_Cisco_ASA_5505_IPSec_VPN_Example) but now I'm trying to connect an ASA to an ASG.

The ASA doesn't have a fixed IP address but the ASG does.

I tried to use the example above and changed the Gateway Type: Initiate connection to respond only...
On the ASA site I send some packets to the ASG LAN to bring the tunnel up.
Live Log shows me that something is happening but the tunnel is still down.

Any ideas?

Thanks for your support!
Kind regards,

This thread was automatically locked due to age.

Parents

0 BAlfson over 13 years ago

cannot route -- route already in use for "X_tunnel5"

It appears that two of the remote locations have the same subnet, or that you already have a tunnel defined with the same ASA. Is that possible?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 Wolfman over 13 years ago in reply to BAlfson

[1 of 1 IPSec SAs established]

I missed the forest for the trees... I had a VLAN configured with the same subnet....

Thank you!

Cheers
Wolfgang
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Wolfman over 13 years ago in reply to BAlfson

[1 of 1 IPSec SAs established]

I missed the forest for the trees... I had a VLAN configured with the same subnet....

Thank you!

Cheers
Wolfgang
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data