Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 1 subscriber
  • Views 1340 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

S2S IPSEC with mulitple IP addresses

mkleine
Greetings,

I'm running multiple IPSEC S2S connections and would like to use two IP different IP addresses to connect from the external interface.

I have one IP address up and running with multiple connections on the device address in the ETH0 (external) interface using x.x.x.106.

I'd like to set up a second IP address x.x.x.107 to connect to a different set of IPSEC S2S sites. x.x.x.107 is defined as an additional address on the same ETH0 interface as x.x.x.106.

However, in setting up the IPSEC connection, I can select only the 'external' interface (x.x.x.106), and I haven't figured out how to make this work.

Any thoughts?

Mark


This thread was automatically locked due to age.
Parents
  • 0
    I'm thinking that the choices made in Uplink balancing will prevent developing the ability to use Additional Addresses where "Primary Uplink Addresses" now can be used - including in IPsec Connection definitions.  I can't think of any reason that using VLANs wouldn't work.

    Cheers - Bob
Reply
  • 0
    I'm thinking that the choices made in Uplink balancing will prevent developing the ability to use Additional Addresses where "Primary Uplink Addresses" now can be used - including in IPsec Connection definitions.  I can't think of any reason that using VLANs wouldn't work.

    Cheers - Bob
Children
No Data