Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSL-VPN Howto configure Gateway / DHCP

Hi Folks!

I cannot find a setting to configure the gateway for a SSL-VPN Login User?! My Default VPN-Pool for SSL is the subnet 10.0.104.0/24. This subnet is also configured as a VLan with the corresponding Gateway ip 10.0.104.1. Unfortunatly that is not true for the SSL-VPN DHCP mechanism. Where can i set the default route for this subnet?

thanks in advance


This thread was automatically locked due to age.
Parents
  • If you have defined a vlan104=10.0.104.0/24 in the Astaro or your network, and "VPN Pool (SSL)" is 10.0.104.0/24, then you will experience addressing problems.

    If you simply reset the "VPN Pool (SSL)" to the default 10.243.2.0/24, I believe your problems would disappear.

    Cheers - Bob
  • If you have defined a vlan104=10.0.104.0/24 in the Astaro or your network, and "VPN Pool (SSL)" is 10.0.104.0/24, then you will experience addressing problems.

    If you simply reset the "VPN Pool (SSL)" to the default 10.243.2.0/24, I believe your problems would disappear.

    Cheers - Bob


    Mr. Bob, 

    actually i´am not fully satisfied with this solution, because i don´t like blackboxing and automagic mechanisms, but for now this solves my problem indeed.

    thanx a lot [:)] 

    cheers, johannes
Reply
  • If you have defined a vlan104=10.0.104.0/24 in the Astaro or your network, and "VPN Pool (SSL)" is 10.0.104.0/24, then you will experience addressing problems.

    If you simply reset the "VPN Pool (SSL)" to the default 10.243.2.0/24, I believe your problems would disappear.

    Cheers - Bob


    Mr. Bob, 

    actually i´am not fully satisfied with this solution, because i don´t like blackboxing and automagic mechanisms, but for now this solves my problem indeed.

    thanx a lot [:)] 

    cheers, johannes
Children
No Data