This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PPTP connection problem

Dears,

I have PPTP configured in my window 7 PC but I faced the following problem:
-When I leave the "Use default gateway on remote network"check box (in PPTP-->properties-->Networking-->IP v4-->properties-->Advanced) checked
I can only connect to the remote network behind the Astaro v 8.2, but can not connect to the internet.
-and visa verse when I uncheck the previous check box I can connect to the internet but can not connect to the remote network behind the Astaro.

Please I need yours advice.
Thanks,
Mostafa Ahdy

This thread was automatically locked due to age.

Parents

0 most_ahdy over 13 years ago

Dears,
Thanks for your reply, but I search hard to find how to implement split-tunnel within pptp vpn, the solution I found was as I mentioned above "check box (in PPTP-->properties-->Networking-->IP v4-->properties-->Advanced) unchecked,
but this disconnect me from the remote network but this can be solved by implementing static route in the window to the remote network , but this static route disappear as I disconnect the vpn.
Please advise if there are any other solutions.
Thanks
Mostafa Ahdy
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 most_ahdy over 13 years ago

Dears,
Thanks for your reply, but I search hard to find how to implement split-tunnel within pptp vpn, the solution I found was as I mentioned above "check box (in PPTP-->properties-->Networking-->IP v4-->properties-->Advanced) unchecked,
but this disconnect me from the remote network but this can be solved by implementing static route in the window to the remote network , but this static route disappear as I disconnect the vpn.
Please advise if there are any other solutions.
Thanks
Mostafa Ahdy
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data