This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

8.201 Firmware Broke our Site to site PBX ext calling using IAX Protocol

Hi guys,

We have 2 offices. One in Toronto and one in New York. Before the firmware upgrade we were able to dial by extension and everything worked. As soon as we did the upgrade in Toronto then we were not able to call NY by extension but NY was able to call us because they were still on the old firmware. As soon as I upgraded last night NY to latest firmware now we are not able to call by extension from neither sites.

What could`ve been changed in our site to site VPN tunnel ?

Thanks.

Also got this from logs:
2011:08:24-08:32:45 yyz-astaro-1 pluto[7591]: "S_TOG VPN" #288: initiating Quick Mode PUBKEY+ENCRYPT+TUNNEL+UP to replace #282 {using isakmp#285}
2011:08:24-08:32:45 yyz-astaro-1 pluto[7591]: "S_TOG VPN" #288: sent QI2, IPsec SA established {ESP=>0x8a05864b 0xc5799827 0x174ed616

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 14 years ago

can we restore to 8.103 without rebuilding the OS
You will need to reinstall from ISO, then restore a 8.103 config backup that you've saved off of the system. About a 20-25 minute process on decent hardware.
Cancel
Vote Up 0 Vote Down

Cancel
0 tog over 14 years ago in reply to Scott_Klassen

thanks Scott unfortunatelly we have no`one to do that at the remote site so we need to fix this. I wish I understand what I need to do with NAT like the other user mentioned. I have a call scheduled for 5:30 with Astaro today.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 tog over 14 years ago in reply to Scott_Klassen

thanks Scott unfortunatelly we have no`one to do that at the remote site so we need to fix this. I wish I understand what I need to do with NAT like the other user mentioned. I have a call scheduled for 5:30 with Astaro today.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data