This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSEC won't establish with NAT traversal asg v7 to v8.2

I upgraded our hub firewall terminating 34 tunnels initiated from v7.509 asg's, and only had 30 of 34 tunnels establish. I noticed the 4 that wouldn't establish were using nat traversal across another router(FIOS router or Linksys WRT54g). No matter what I tried, I couldn't get the tunnel to establish. These tunnels were esstablished on 8.103 prior to the v8.2 upgrade. I reverted back to 8.103 to resolve the issue.

Brian

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 14 years ago

Now I've got to figure out if I've got a 8.1x backup available so that I can revert using an ISO
Look in WebAdmin>>Management>>Backup/Restore.
Cancel
Vote Up 0 Vote Down

Cancel
0 MillardJK over 14 years ago in reply to Scott_Klassen

Look in WebAdmin>>Management>>Backup/Restore.

Thanks! I found both 3.102 and 3.103 version backups, and it looks like there's a full ISO (not a patch) of 3.103, so I should be able to get things reset tonight after I get home.
Cancel
Vote Up 0 Vote Down

Cancel
0 MillardJK over 14 years ago in reply to MillardJK

The ISO on the website is 8.103, and my pre-8.200-upgrade backup was available on the ASG, so I downloaded both and reverted back to 8.103. As soon as the config was restored (and DNS got updated!), I was able to use L2TP just the way I'd become accustomed.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 MillardJK over 14 years ago in reply to MillardJK

The ISO on the website is 8.103, and my pre-8.200-upgrade backup was available on the ASG, so I downloaded both and reverted back to 8.103. As soon as the config was restored (and DNS got updated!), I was able to use L2TP just the way I'd become accustomed.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data