This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSEC won't establish with NAT traversal asg v7 to v8.2

I upgraded our hub firewall terminating 34 tunnels initiated from v7.509 asg's, and only had 30 of 34 tunnels establish. I noticed the 4 that wouldn't establish were using nat traversal across another router(FIOS router or Linksys WRT54g). No matter what I tried, I couldn't get the tunnel to establish. These tunnels were esstablished on 8.103 prior to the v8.2 upgrade. I reverted back to 8.103 to resolve the issue.

Brian

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 14 years ago

These tunnels were esstablished on 8.103 prior to the v8.2 upgrade

Multiple concurrent IPSEC tunnel failure has been reported by others as well. 8.200 soft-release is not final code and has some issue. These are being resolved for the release of 8.200 GA (final version) and a companion 8.201 u2d package. I would suggest waiting until these are both available before migrating to the 8.2x line.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 14 years ago

These tunnels were esstablished on 8.103 prior to the v8.2 upgrade

Multiple concurrent IPSEC tunnel failure has been reported by others as well. 8.200 soft-release is not final code and has some issue. These are being resolved for the release of 8.200 GA (final version) and a companion 8.201 u2d package. I would suggest waiting until these are both available before migrating to the 8.2x line.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data