This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSL VPN no traffic from Client to Server

Hello,

i need some help with my SSL VPN.

I configured it as usual with standard configuration.
I allowed 3 networks for the Clients.

When i connect (with Viscosity) i get the routes:

10.0.200/24        10.242.2.5         UGSc            0        3    tun1
10.0.201/24        10.242.2.5         UGSc            0        0    tun1
10.0.202/24        10.242.2.5         UGSc            0        0    tun1

but if i want to ping a server in the 10.0.202.0/24 network i doesn't get an answer... (yes i allow ping and ICMP through the firewall)
http or any other service doen't work, too...

Can anybody help me ?

Thanks

This thread was automatically locked due to age.

Parents

0 BAlfson over 14 years ago

Hi, billic25, and welcome to the User BB!

Is this is a new installation, and do you still have your old router in place? If so, then traffic probably reaches the seerver, but it sends the response to the wrong place. If you can't change the server's default gateway to the internal interface of the Astaro, then you'll need a route either in your existing router or in the server.

If that's not the problem, do you see anything blocked in the Packet Filter log or the Intrusion Prevention log?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 14 years ago

Hi, billic25, and welcome to the User BB!

Is this is a new installation, and do you still have your old router in place? If so, then traffic probably reaches the seerver, but it sends the response to the wrong place. If you can't change the server's default gateway to the internal interface of the Astaro, then you'll need a route either in your existing router or in the server.

If that's not the problem, do you see anything blocked in the Packet Filter log or the Intrusion Prevention log?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data