Hi I'm getting the below issue when configuring a site 2 site ipsec VPN, unfortunately I only have control over 1 end so I'm just copying the config from the Cisco I'm replacing and hoping (which fortunately is going well on the other tunnels)
"S_BlahBlah VPN" #60: max number of retransmissions (2) reached STATE_MAIN_I3. Possible authentication failure: no acceptable response to our first encrypted message
"S_BlahBlah VPN" #60: starting keying attempt 5 of an unlimited number
"S_BlahBlah VPN" #62: initiating Main Mode to replace #60
"S_BlahBlah VPN" #62: received Vendor ID payload [draft-ietf-ipsec-nat-t-ike-02_n]
"S_BlahBlah VPN" #62: ignoring Vendor ID payload [FRAGMENTATION c0000000]
"S_BlahBlah VPN" #62: enabling possible NAT-traversal with method RFC 3947
"S_BlahBlah VPN" #62: ignoring Vendor ID payload [Cisco-Unity]
"S_BlahBlah VPN" #62: received Vendor ID payload [XAUTH]
"S_BlahBlah VPN" #62: ignoring Vendor ID payload [cafe14c9f3c9f05be9eaee4dbdec41dd]
"S_BlahBlah VPN" #62: ignoring Vendor ID payload [Cisco VPN 3000 Series]
"S_BlahBlah VPN" #62: NAT-Traversal: Result using draft-ietf-ipsec-nat-t-ike-02/03: no NAT detected
"S_BlahBlah VPN" #62: Informational Exchange message must be encrypted
"S_BlahBlah VPN" #65: discarding duplicate packet; already STATE_MAIN_I3
"S_BlahBlah VPN" #65: byte 2 of ISAKMP Hash Payload must be zero, but is not
"S_BlahBlah VPN" #65: malformed payload in packet
Any ideas?
Thanks in advance
Mark
This thread was automatically locked due to age.
