This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Remote access from site-to-site client

I need SSL Remote Access users connecting to a Remote office to have access to the Main office.

I have SSL site-to-site with the Remote office being the site-to-site client.
Remote access users connecting to Main can access Remote without difficulty.

But I also need remote access users connected to the Remote site to be able to access the Main office:

ssl client
|
RemoteMain

I created a unique SSL VPN pool at Remote and also added that same network to the Remote Networks list in the site-to-site config at Main.
I added Main's network to Remote Access/Local Networks at Remote.

I uploaded the new site-to-site definition at Remote, but it doesn't work. Any ideas what I might be missing?
Thanks,
Alan

This thread was automatically locked due to age.

0 BAlfson over 14 years ago

It sounds like it should work. Maybe you could get an idea from: Howto - Allow Remote Access Users to Reach Another Site via a Site-to-Site Tunnel.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 alehman over 14 years ago

Thanks. I was using that as a guide, but it's intended for remote access users connecting at Main (site-to-site server). I tried to extend the concept to the opposite scenario, with the site-to-site configuration being made at Main and uploaded to Remote.

Traceroute from a remote access user ends at the VPN IP of Main. It appears the traffic dies at Main's Astaro. I have Automatic Packet Filter Rules enabled for the site-to-site VPN.
Cancel
Vote Up 0 Vote Down

Cancel
0 alehman over 14 years ago

Never mind. I was missing a route back on a few systems at Main. It's working now.
Sorry about that.
Cancel
Vote Up 0 Vote Down

Cancel