Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 14 replies
  • Subscribers 1 subscriber
  • Views 1068 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cisco VPN to 3 Networks

unst
Hi all,
today i activated the Cisco VPN and after i removed the domain name unter RemoteAccess -> Advanced it worked well.
But when i put more than 1 "local network" in the box on the configuraiton site i can only access the very first network.

i tested it. it always just set the route to the first network.
have a look at the screens please.

do you know how i can tell the client or the asg to set routes to all networks?
thanks!


This thread was automatically locked due to age.
Parents
  • 0
    Hmmm... However, it is possible to use Network Groups in the SSL VPN where the same potential exists.  Interesting.

    Cheers - Bob
  • 0 in reply to BAlfson
    Hmmm... However, it is possible to use Network Groups in the SSL VPN where the same potential exists.  Interesting.


    Heresy! Burn him! =)

    Srsly: you're right, this is not very homogeneous throughout WebAdmin, due to the fact that features were added at different times by different people. However a group wouldn't help here as the issue is located at rather deep layer where it would have been expanded anyways.
Reply
  • 0 in reply to BAlfson
    Hmmm... However, it is possible to use Network Groups in the SSL VPN where the same potential exists.  Interesting.


    Heresy! Burn him! =)

    Srsly: you're right, this is not very homogeneous throughout WebAdmin, due to the fact that features were added at different times by different people. However a group wouldn't help here as the issue is located at rather deep layer where it would have been expanded anyways.
Children
No Data