This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cisco VPN to 3 Networks

Hi all,
today i activated the Cisco VPN and after i removed the domain name unter RemoteAccess -> Advanced it worked well.
But when i put more than 1 "local network" in the box on the configuraiton site i can only access the very first network.

i tested it. it always just set the route to the first network.
have a look at the screens please.

do you know how i can tell the client or the asg to set routes to all networks?
thanks!

This thread was automatically locked due to age.

Parents

0 BAlfson over 14 years ago

Hmmm... However, it is possible to use Network Groups in the SSL VPN where the same potential exists. Interesting.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 unst over 14 years ago in reply to BAlfson

okay, i tried with 2 and 4 networks - it stays the same. do you also want the shell-output? if you want i can paste it.

i already read the post you linked, i needed it to fix the "domain name"-lenth problem.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 unst over 14 years ago in reply to BAlfson

okay, i tried with 2 and 4 networks - it stays the same. do you also want the shell-output? if you want i can paste it.

i already read the post you linked, i needed it to fix the "domain name"-lenth problem.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 d12fk over 14 years ago in reply to unst

Yes, but you had no domain name set, so it's not that closely related but rather the same category of problem... something with the Cisco Unity modecfg attributes.
Cancel
Vote Up 0 Vote Down

Cancel