This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Use a station as a router

Hi,
I'm new in the VPN technology and i'm really lost about some features [:(]

We need to make a demonstration to one of our customer.

For this, we need a tunnel between our datacenter and the customer.

I have successfully configured a VPN SSL remote access on my laptop.
My laptop ping the remote network.

I have enable routing on this laptop.

I configure a thin client with this laptop as a gateway.
I can ping the Astaro virtual interface, but i can't reach the remote vlan.
I have created FW rule that allow any network, any services to access any network. 

Maybee i forgot to configure something ?

A little help will be very apprecied.
Thanks.


Configuration : 
Laptop (Routing enabled)
192.168.0.100
255.255.255.0
GW : 192.168.0.254
this laptop is connected to the remote network with the VPN SSL remote access.

Thin client
192.168.0.101
255.255.255.0
GW : 192.168.0.100


This thread was automatically locked due to age.
Parents
  • Hi BAlfson

    As i explain previously, i can ping the 172.16.1.0/27 from the laptop, the VPN is working !

    The packet filter rule is ok, checking the automatic filter rule give me the same result.

    I didn't create the 168.168.0.0 -> 172.16.16.6 static route in the astaro... why i should ?

    This can be my solution, i will try this as soon i can and give a feed back.
    Thanks.
Reply
  • Hi BAlfson

    As i explain previously, i can ping the 172.16.1.0/27 from the laptop, the VPN is working !

    The packet filter rule is ok, checking the automatic filter rule give me the same result.

    I didn't create the 168.168.0.0 -> 172.16.16.6 static route in the astaro... why i should ?

    This can be my solution, i will try this as soon i can and give a feed back.
    Thanks.
Children
No Data