Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 1 subscriber
  • Views 2169 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Failover IPSEC VPN from internal to external IPs

BSavage
We have our primary hub ASG with Internal adressing on Eth4, and Internet addressing on Eth1. Our remote Astaro has same setup, with Eth1 on the internal IP addressing, and Eth2. We currently only have the One IPSEC tunnel configured over the private IP link, with the hub side at respond only, but would prefer failover to the external link. I'm not sure if I can do this with the one IPSEC config, can I? 

Can I use the Availability groups on jsut the remote ASG's IPSEC gateway config along with the failover/uplink option? I'm not familiar with using the availability group in the IPSEC gateway, and don't want to set this up incorrectly. Thanks

Brian


This thread was automatically locked due to age.
Parents
  • 0
    In that case, how about configuring DynDNS (the service is free for up to five hosts) in 'Network Services >> DNS'?  That would allow you to have a defined target and so avoid "Respond only" mode.

    Cheers - Bob
Reply
  • 0
    In that case, how about configuring DynDNS (the service is free for up to five hosts) in 'Network Services >> DNS'?  That would allow you to have a defined target and so avoid "Respond only" mode.

    Cheers - Bob
Children
No Data