This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

how to make RoadWarrior client speak to remote site?

Hi,
My setup is the fallowing:
I have two sites. One site that we can call the main site and the other on that we can call the remote site! They are link together by a ssl site-to-site vpn. I have some users that connect in ssl vpn to the main site and I want the to be able to speak to the remote site. How can I do that.

(SSL USERS)
|
MAIN SITEREMOTE SITE

What I already did is add the remote network to the network list in the remote access configuration. Now when I do a traceroute from one of the ssl client to an address on the remote site the request goes through the vpn tunnel and then die on the astaro. Witch make sense because I need to add a route on the astaro but how can I do this?

Thanks

This thread was automatically locked due to age.

Parents

0 BAlfson over 14 years ago

I'm sure it also works with SSL remote access. Did you also install the new client configuration file for SSL remote access?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 alexis101 over 14 years ago in reply to BAlfson

Yes,but i just checked and the route information are not in the client config file anyway.... and like I said the traceroute dies on the astaro. So the ssl client know what to do with the packet but astaro don't!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 alexis101 over 14 years ago in reply to BAlfson

Yes,but i just checked and the route information are not in the client config file anyway.... and like I said the traceroute dies on the astaro. So the ssl client know what to do with the packet but astaro don't!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data