This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSEC VPN ID Question

Hello,

I am stuck on a issue which is probably very simple but cannot work it out [:S]  Any help would be appreciated.

I am trying to set up a IPSEC Site2Site Tunnel allong the following setup:

(LocalNet:192.168.210.0/24)--(LocalAstaro WAN:192.168.0.105)--(LocalRouterWAN:81.222.205.125)
===Internet===
(HeadOfficeWAN:85.196.155.70)--(HeadOfficeNet:192.168.150.0/25)

So the local astaro is stuck behind a router which gives it the IP:192.168.0.105

Now I know that the solution to this is to enable NAT (Done)
and set the VPN ID at the local side to 81.222.205.125 and it should work.
As the Headoffice VPN is set to communicate to 81.222.205.125

The question is how to set the local VPN ID to 81.222.205.125???

I had thought this would be set in Remote Gateway -- VPN ID Type: IP Address -- VPN ID 81.222.205.125
but this seems to have no effect?

The tunnel that is displayed is:
SA: 192.168.210.0/24=192.168.0.105   85.196.155.70=192.168.150.0/24
VPN ID: 192.168.0.105
Error: No connection

Clearly the tunnel will not work until I am able to set the VPN ID: 81.222.205.125
but how????????? [:O]

Thanks


This thread was automatically locked due to age.
Parents
  • The VPN ID can't be changed if you use PSK authentication. However, it should work if you configure the ASG's VPN ID to "192.168.0.105" on the head office machine. Or you could use RSA/x509 based authentication which always gives you better security than PSK.
Reply
  • The VPN ID can't be changed if you use PSK authentication. However, it should work if you configure the ASG's VPN ID to "192.168.0.105" on the head office machine. Or you could use RSA/x509 based authentication which always gives you better security than PSK.
Children
No Data