This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSec Site 2 Site Not Functioning

I'm having a fairly odd issue. I have a site to site vpn between an ASG and a netgear firewall. It used to work fine until I updated to 8.0. The VPN connects and shows as up but it will not pass traffic. I have tried pinging from computers on both local and remote networks as well right from the ASG and it doesn't work. Both show routes have been added...

Thoughts?

THanks!

-Danny

This thread was automatically locked due to age.

Parents

0 BAlfson over 15 years ago

Also, please show a pic of the 'Site-to-site VPN tunnel status', which is seen when you first select 'Site-to-Site VPN'.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 15 years ago

Also, please show a pic of the 'Site-to-site VPN tunnel status', which is seen when you first select 'Site-to-Site VPN'.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 dgriffin over 15 years ago in reply to BAlfson

Sure! That would probably help........

these are the netgear side, if it helps:
IKE:

IPSEC:

ipsec logs.zip
Cancel
Vote Up 0 Vote Down

Cancel