Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 27 replies
  • Subscribers 1 subscriber
  • Views 11165 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Ipsec cisco vpn client under mac

equintana
Hi,

I´have a  mac 10.6 and installed cisco vpn client 4.9.
I configured my astaro device with cisco ipsec but can not connect.


Any guide to configure using cisco vpn and astaro?


This thread was automatically locked due to age.
Parents
  • 0
    One possible issue could be the VPNid in the "Local X509 Cert" - check that the 'Hostname' in the certificate is an FQDN that resolves to the IP on your WANVPN interface, and that this is the current Hostname of your Astaro.

    Check that these are the same:
    • 'Management >> System Settings' - 'Hostname' tab - 'Hostname:'
    • 'Remote Access >> Certificate Management' - 'Certificates' - 'VPNId [Hostname]'

    Also, these should be a FQDN that resolves to the IP of "WANVPN (Address)".

    Cheers - Bob
Reply
  • 0
    One possible issue could be the VPNid in the "Local X509 Cert" - check that the 'Hostname' in the certificate is an FQDN that resolves to the IP on your WANVPN interface, and that this is the current Hostname of your Astaro.

    Check that these are the same:
    • 'Management >> System Settings' - 'Hostname' tab - 'Hostname:'
    • 'Remote Access >> Certificate Management' - 'Certificates' - 'VPNId [Hostname]'

    Also, these should be a FQDN that resolves to the IP of "WANVPN (Address)".

    Cheers - Bob
Children