Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 17 replies
  • Subscribers 1 subscriber
  • Views 6625 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

l2tp/ipsec vpn broken after ASG8 install

h3mp
just loaded ASG8 on my ASG220 and imported my v7 config...

everything works fine, apart from l2tp/ipsec clients cannot connect..

all user accounts and certs seem to be there as before..

but windows just hangs connecting (you see port opened, then connecting to... - just hangs there then times out eventually)..

anyone else suffering this? - also, where is the ipsec/l2tp log - cant see anything in the ipsec log, does this have a seperate log?

Thanks

Mark


This thread was automatically locked due to age.
Parents
  • 0
    Mark, I think I'm out of my depth now.  I see that the packet filter blocks only occur after the attempt to establish a tunnel fails, but I don't understand how no other information would be available in the IPsec log.  Does the IPsec log even show that the IPsec process is started when you disable/enable L2TP/IPsec? (Assuming you don't have any other IPsec VPN enabled.)

    Cheers - Bob
Reply
  • 0
    Mark, I think I'm out of my depth now.  I see that the packet filter blocks only occur after the attempt to establish a tunnel fails, but I don't understand how no other information would be available in the IPsec log.  Does the IPsec log even show that the IPsec process is started when you disable/enable L2TP/IPsec? (Assuming you don't have any other IPsec VPN enabled.)

    Cheers - Bob
Children
No Data