This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pix to Astaro ipsec VPN - where is the ESP setting?

fox1977 over 15 years ago

Hi there,

I am just following through the tutorial in the knowledge base to setup a site to site VPN:

http://portal.knowledgebase.net/article.asp?article=284555&p=5956

I am unable to find the ESP setting.  This is mentioned in a few tutorials but i am not sure where it is.  Has it been removed in the later versions?

I am running Astaro internet security gateway 7.504.

We have a working VPN between the a cisco pix 501 and a draytek router thats working fine using the following settings:

ipsec tunnel, high (esp), DES with authentication.  We are using a shared key.

When i try and connect i am getting the following error in the live log on the astaro device:

ignoring informational payload, type NO_PROPOSAL_CHOSEN

Anyone any ideas?  Im starting with a mismatch in IPsec settings

This thread was automatically locked due to age.