This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Site-to-site VPN with network conflicts

I'm trying to set up a IPSEC tunnel between our network and a client network. Our network is 172.16.0.0/24 and there is 10.0.0.0/8.

From our side there are no conflicts, but they already have a 172.16.0.0/24 network.

My thought, since they do not need to access our network, is to create additional addresses (172.16.50.0/24) on our network and use that to connect the tunnel.

Now, how do I make sure that traffic from 172.16.0.0/24 to 10.0.0.0/8 goes through that tunnel, or do I have to use another solution?

This thread was automatically locked due to age.

Parents

0 naughtyrob over 15 years ago

Thanks Bob, this answer saved my day as well.

And, well, thanks erucolindo for the question! [:)]

I did as you suggested and it just worked, but I have a doubt. Do we need an additional address on the interface or creating a host in Definitions/Network would suffice?

Is there any difference between the two approaches?

Thanks!

Roberto
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 naughtyrob over 15 years ago

Thanks Bob, this answer saved my day as well.

And, well, thanks erucolindo for the question! [:)]

I did as you suggested and it just worked, but I have a doubt. Do we need an additional address on the interface or creating a host in Definitions/Network would suffice?

Is there any difference between the two approaches?

Thanks!

Roberto
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data