This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Site to Site VPN needs to masquerade IP

I have setup a Site to Site VPN with a partner but need to have our IP address masquerade as a different IP whenever traffic goes over the VPN to the partner. I cannot seem to find an intuitive way to accomplish this. Any help?

This thread was automatically locked due to age.

Parents

0 bfulford over 16 years ago

I have an old cisco concentrator that allows me to NAT my internal traffic to a public ip before going on to a partners vpn tunnel. I just figured this was possible as well with Astaro.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 16 years ago in reply to bfulford

It just seemed to me that there was an inherent routing issue. What commands do you use with the Cisco to achieve the result you want?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 16 years ago in reply to bfulford

It just seemed to me that there was an inherent routing issue. What commands do you use with the Cisco to achieve the result you want?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data