This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Zombie VPN IP Addresses After Restart

ron-astaro@mcleodnet.com over 17 years ago

I have 2 ASG220 units is an active-active cluster configuration. If I restart the MASTER unit when there are SSL-VPN users active, the WebAdmin Remote Access Status shows multiple IP addresses for users. If I restart again, the numbers increase more. Is this normal operation?

This thread was automatically locked due to age.

Parents

0 ron-astaro@mcleodnet.com over 16 years ago

I still have the problem where after a fail-over when a SSL VPN was up, that the old connection information is still displayed in the Remote Access summary page.

Is there any way to manually clean this up?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 ron-astaro@mcleodnet.com over 16 years ago

I still have the problem where after a fail-over when a SSL VPN was up, that the old connection information is still displayed in the Remote Access summary page.

Is there any way to manually clean this up?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data