This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

OPenVPN Client connects to Server but cannot see local network

Okay...I can successfully connect my roadwarrior client to the OpenVPN server on the ASG.  But...I cannot see any of my internal network (i.e. ping, etc.)  I have played around with NAT rules.  And I still cannot get this thing to work.  

My question is... is there a particualar DNAT or SNAT rule that needs to be applied to allow packets from the tunnel into my local network.  I've tried routing the external address and port to the local network and that did not work.  Any advice would be appreciated.

Thanks,


This thread was automatically locked due to age.
Parents
  • FWIW, you don't need NAT to ping the Internal networks, but you'd want to NAT to EXT if appropriate.

    Assuming you have the ICMP ping and traceroute settings turned on.

    Don't forget to set the DNS proxies, etc. to allow the VPN Pool(s).

    Barry
  • Assuming you have the ICMP ping and traceroute settings turned on [inside the Astaro].


    Hmmm.  You're already inside the network via the VPN (same internal subnet).  You should just be able to ping, traceroute, etc. the device from your computer via the VPN client.  Though to do this from the Astaro itself, you would have to have the features turned on as Barry mentioned.
  • The VPNs I've used with Astaro, including OpenSSL, put the client into one of of the VPN Pools, which are not the same as the LANs.

    Barry
Reply Children
  • The VPNs I've used with Astaro, including OpenSSL, put the client into one of of the VPN Pools, which are not the same as the LANs.
    Barry


    Barry, you are absolutely correct about the pools - my bad.

    I've just tested to be sure, pinging via the VPN is working with even with the checkbox for allowing pinging across the Astaro set to disabled.