This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSL VPN Help

I'd like a little help with getting the SSL Vpn setup. I'm running V7.05 currently. I've configured the firewall according to the manual, but when I try to access https://my ip address:443 I just get a page not be displayed error. I've checked both my packet filter and IPS logs to see if something is getting blocked, but there is nothing. I have a packet filter rule for HTTPS and SSL set to any any. I am using NAT, however I do not have any SNAT translations for SSL. The only error messages that I can see are in the OpenVPN log -

penvpn[337]: 4.21.201.156:4240 WARNING: Bad encapsulated packet length from peer (32811), which must be > 0 and 131072] S=[131072->131072]
2007:10:09-15:19:30 (none) openvpn[337]: TCPv4_SERVER link local: [undef]

This thread was automatically locked due to age.

0 SilverOne over 18 years ago

I'd like a little help with getting the SSL Vpn setup. I'm running V7.05 currently. I've configured the firewall according to the manual, but when I try to access https://my ip address:443 I just get a page not be displayed error. I've checked both my packet filter and IPS logs to see if something is getting blocked, but there is nothing. I have a packet filter rule for HTTPS and SSL set to any any.
[undef]

Can you try the link without the :443 ?
So https://your_IP_Address
Made Packet filter rules? Can you set it up as manual told you so:

Port: Select the port that all SSL VPN clients must use. By default, this is set to 443.
Automatic packet filter rules: Once the SSL VPN tunnel is successfully established, the
packet filter rules for the data traffic will automatically be added. After the completion of
the connection, the packet filter rules will be removed.

Give it a try....
Cancel
Vote Up 0 Vote Down

Cancel