This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

V7 not showing all tunnels

Hi,

I replaced one ASG V6 with 4 VPN-tunnels with a new V7. 2 of the 4 tunnels go to the same remote-ASG, connecting to LAN and DMZ. I made a complete new setup and everything looks quite good.

The dashboard says: 'Site2Site VPN is active with 2 of 3 online tunnels' and on the register Site2site VPN the status shows one connection with '2 of 2 SAs established' and one with '1 of 1 SAs established'.
There is nothing to see of the fourth tunnel, but it's working. I have full access to the remote site of this tunnel, but no information in the ASG.

Any ideas, what's wrong.

This thread was automatically locked due to age.

0 wk_03 over 18 years ago

Hi,

just an update.

To verify the behaviour, I set up a new V7 on a virtual machine and did the same settings. It is just alike. I can work with all four tunnels, but the forth is not shown.
Cancel
Vote Up 0 Vote Down

Cancel
0 wk_03 over 18 years ago in reply to wk_03

Hi,
another update.

I have a new ASG120, which I upgraded to V7.080 to verify the behavior.

First I only installed the tunnel, that is never shown on the old machines and it is the same.

Dashboard says: 'Site2Site VPN is active with 0 of 1 online tunnels.'

and the Site-to-site-VPN window shows:

'There is no IPSec Site-to-Site status information available.'

But the tunnel is up and running and I can reach the remote ASG.

Then I installed a second VPN-connection and this one is totally OK. It is shown like it should.
Cancel
Vote Up 0 Vote Down

Cancel