This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[7.001] IPSEC Connections not started aufter reboot

I found thqt after a reboot of a V7 Astaro a Site2Site VPN isn't coming up.

I reproduced this error on 2 different V7 systems: Only stopping the Site2Site VPN Connection and starting it again solves this issue. It seems that IPSEc is started before the selected Interface is up.

Maybwe helpfull: Both System are using an PPOE Interface as Default GW.

Regards KoC

This thread was automatically locked due to age.

0 drees over 18 years ago

That's a bad problem to have. Make sure you open a trouble ticket with Astaro!
Cancel
Vote Up 0 Vote Down

Cancel
0 Joerg_Riether over 18 years ago in reply to drees

you waited about 10 mins? I am sure the asl tries to open the tunnel long time before it gets the ppoe established. Could you try to test it again but wait about 10 mins before manually killing and restarting the tunnel and tell us your results?

best regards
Joerg
Cancel
Vote Up 0 Vote Down

Cancel
0 aj_03 over 18 years ago in reply to Joerg_Riether

i have the same problem with 7.002. Using DHCP at external Interface (CableModem). My 2 Tunnels doesn's start until manual disable/enable.

I have waited about 30' ... without any changes ...
Cancel
Vote Up 0 Vote Down

Cancel
0 sanman over 18 years ago in reply to aj_03

Hello,

i have the same Problem with a IPSec connection from a ASL 6.304 to ASL 7.002 also with ASL 6.304 to ASL 6.304. All internetconnection are PPPoE.
Does anyone has a workaround to fix this problem?
I talk to astaro since a few month ago. But nothing happend.

Regards
Michael
Cancel
Vote Up 0 Vote Down

Cancel