This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VPN interface issue

Hi all.

I have an ASG120 box. I just set it up for L2TP VPN access for external users. My external interface has 2 public IP addresses attached to it (routing from external to one of the 2 internal networks is based on the public address people connect to).

While watching the L2TP logs, I noticed that the VPN process is binding to one of the two external addresses, which happens to be the wrong address. How can I get it to listen on the address specified as an additional address? Did I make a wrong selection in my configuration at some point? Or would I have to swap the primary and additional addresses on the external interface? Any ideas?


This thread was automatically locked due to age.