This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

routing trafic from pptp pool to local network?

hi all,

i have setup roadwarior acces to ma network trough astaro v4.

To be able to brows and use network i have manualy assigne IP to pptp users which are in same range as adress of my local network. and all is fine, i can use network resources, etc.

This is a problem when some users connect form home, their local networks use same IPS and that can get sometimes confusing and stuff dont work as they should i presume.

I would like that pptp users use IP from pptp ip pool form range 10.x.x.x. but how can i allow acces to computers on LAN. How to bind pptp ip adress with one from my local network?


This thread was automatically locked due to age.
Parents
  • Getting VPN access to work using PPTP should be a no-brainer. Just stick with the default PPTP-Pool address range for the remote connections. Traffic  from your remote PCs will be automatically routed to the Internal network. Make sure that your packet filter rules allows the traffic to pass.

    It is also a good idea to create an additional  masquerade rule, to masquerade the PPTP-Pool network behind the WAN interface. This allows Internet access for the remote machines on a PPTP VPN connection
Reply
  • Getting VPN access to work using PPTP should be a no-brainer. Just stick with the default PPTP-Pool address range for the remote connections. Traffic  from your remote PCs will be automatically routed to the Internal network. Make sure that your packet filter rules allows the traffic to pass.

    It is also a good idea to create an additional  masquerade rule, to masquerade the PPTP-Pool network behind the WAN interface. This allows Internet access for the remote machines on a PPTP VPN connection
Children