This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

From ASC to MS DC 2003 - Logon Option

Hi folks,

has anybody used the ASC Logon-Option to connect to MS Domain Controller at startup? And is it still working?
What have i to pay attention for at configuration on ASL-site and DC-site?
The error-message after ASC connected over IPSec to DC is, that the name and password are wrong (typing error?!)!? They aren't... i can play with my keyboard very well :-)
Could it prevent an attitude in the group-policies from MS DC??

Well, thanks for reading...
ako

This thread was automatically locked due to age.

Parents

0 maygyver over 20 years ago

pleas check packet filter log, for blocked packets during login, on ASL/ASB side. try to turn off firewall in ASC, or turn on logging, and have a look into it.

Astaro user since 2001 - Astaro/Sophos Partner since 2008
Cancel
Vote Up 0 Vote Down

Cancel
0 AKo over 20 years ago in reply to maygyver

Thanks for reply...
There is nothing in packet filter log, because i have an rule like:
VPNIPSECNET -> all -> all -> allow

The firewall in ASC is disabled...
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 AKo over 20 years ago in reply to maygyver

Thanks for reply...
There is nothing in packet filter log, because i have an rule like:
VPNIPSECNET -> all -> all -> allow

The firewall in ASC is disabled...
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data