This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem Deleting Remote Keys

I setup a connection a while back and since then I changed some things and now I need to recreate my remote keys for my Roadwarrior IPSEC connections.  So attempting to delete the remote keys, I get the following error:

"The certificate 'Joe_Schmo' (or its dynamic network definition) is still in use."

The connection is not in use, nor is the cert.  The dynamic definitions for the connection can not be deleted by me.  They are locked and the only action I can perform on them is editing the description.

So I could just create new ones and forget about these but I am halted when trying to because the VPN ID is the same as the previous.

So, any suggestions on how to delete these certs?  Is there a manual way I can do it(without voiding support)?  Is there something I'm totally missing?

Thanks in advnace.

This thread was automatically locked due to age.

Parents

0 NimmdirKeks over 20 years ago

Hi,

just look around in your definitions, possible they are used in a filter, nat rule or routing. So you need to delete the definitions the key made, before you can remove the key.

Chris
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 NimmdirKeks over 20 years ago

Hi,

just look around in your definitions, possible they are used in a filter, nat rule or routing. So you need to delete the definitions the key made, before you can remove the key.

Chris
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 shultzm over 20 years ago in reply to NimmdirKeks

Thanks, but after some fiddling I found out that in the connection properties, the cert was still listed as allowed. And when moving it back over to the disallowed spot, you still have to click save.
Cancel
Vote Up 0 Vote Down

Cancel