Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 1 subscriber
  • Views 708 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VPN No Data-Transfer after update to 6.001

firebear_01
Hi,
on Version 5.0xx i implementet Roadwarrior-VPNs and everything was fine till 5.205 but after updating to 6.001 and installing of the 5.205 Backupfile i can connect with my ASC 8.2 but no byte will be transfered in the tunnel from ASL to ASC.
Are there things wich i have to change ?????

tanks for any information
firebear

PS: (written some times later)
Now i have rebotet the firewall-device and newly downloaded the vpn-config-file and importet it into ASC 8.2.     ->  no success

PS: (written some times later)
Now i have set off ips on the ASL   ->   no success
turned it on again.

PS: (written some times later)
Now i have set off deflate on the ASL and IP-Compression plus Dead-peer-detection on the ASC    ->  it works
Dead-peer-detection on the ASL is on.


This thread was automatically locked due to age.
Parents
  • 0
    Hi,
    sometimes after the asc-vpn works, all users of standard vpn announced that their vpn tunnels beaks every vew minutes and reconnect after about a minute. so i reinstalled 5.06 now everything works again but theres no system to investigate the failures. next week i'll install a paralell vpn-gate with 6.001 to test again.

    thanks
    firebear
  • 0 in reply to firebear_01
    There appears to be a catastrophic failure in 6.001 with no information given from the Astaro staff.  

    No solutions are found on these forums and all relevant information is requested via email.
Reply Children
No Data
Cookie Information Banner