Hello all, I've been reading through the boards for about the last 2 hours looking for this and I'm not seeing anything that I think really matches what I have.
Anyway I'm on ASL 5.015 and SSH Sentinel 1.4 (build 132)
I followed the directions on the howto for IPSec Roadwarrior setup. Everything looks ok in ASL, I have NAT to allow the VPN to the internet and a filter rule to allow the traffic to my internal network. Also in the VPN settings NAT-T is enabled.
On the client everything is setup as the doc states and NAT-T is also enabled. I have tried moving the remote network from internal to any on both sides with no success. I can run the diagnostics successfully and then connect. From there however I cannot ping anything on the internal network nor reach the internet. The internal network and VPN IP are in different networks. From my understanding of what I'm seeing it appears as if nothing (except the basic connection) is leaving the client as SSH Sentinel does not report any inbound or outbound traffic.
I'm hoping I'm just missing something obvious here, but I'm sure I have it setup like the doc and didn't notice anything in the forums for this.
Thanks for your help!
This thread was automatically locked due to age.