This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PPTP VPN connects but cannot reach internal lan

I connect to the firewall with MS PPTP VPN, no problem. Using local authentication, get correct ip everything, but I cannot ping or connect to any internal pc's. What config and I missing?
Thanks
hemps [:S]

This thread was automatically locked due to age.

Parents

0 Cory over 21 years ago

Make sure that you have the proper packet filter rules in place. Also make sure you don't have the same address scheme for the PPTP-Pool as your internal network otherwise you will run into routing conflicts.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Cory over 21 years ago

Make sure that you have the proper packet filter rules in place. Also make sure you don't have the same address scheme for the PPTP-Pool as your internal network otherwise you will run into routing conflicts.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 hemps over 21 years ago in reply to Cory

Thanks I did not have any rules in, I will try that.

Ryan
Cancel
Vote Up 0 Vote Down

Cancel
0 VelvetFog over 21 years ago in reply to hemps

Also check your ICMP and Ping settings. If they are turned off, your Pings won't go through, even if you open up for general traffic via packet filtering.
Cancel
Vote Up 0 Vote Down

Cancel